Ok the instructions above are somewhat correct and definitely helped me out, but this is what was different for me.1st: Unplug your alarm from the Wall Outlet. Now that you know the Installer Code, you can exit programming mode by pressing *99, and would then be able to reenter programming by keying in the Installer Code + 800, if necessary. Again, after entry of the final digit, you'll hear 3 beeps, and to verify the code was taken correctly, you can then press #20 to have the system read it back to you. You can also simply change the Installer Code to a 4 digit code of your choice by pressing *20 + New 4 Digit Code. Each digit is followed by a beep, and the final digit is followed by 3 beeps. For example, if the Installer Code is 9876, it would be displayed as 09 08 07 06. The code will be displayed as four 2-digit numbers. ![]() You can then hit #20 to view the current installer code. If done correctly, the keypad should display 'Installer Code 20' on the display. Once the system is powered down, plug the transformer back into the wall and immediately press * and # together on the FA260 keypad. ![]() ![]() You will find the battery inside the beige metal cabinet that houses the First Alert control panel. Just like with a VISTA Series panel, you will need to remove the security system transformer from the wall outlet and unhook one lead from the backup battery, which will power down your system.
0 Comments
Leave a Reply. |